how does the bonding inteface get mac address on linux

It uses the bond settings from the IPv4 address, like a second IPv4 address. IPv6 does not need bond0:1 or similar workarounds - just use bond0 for every address. If you also want to add IPv6 addresses, it is a little different again, as you need to add this (as an example): iface bond0 inet6 static

You can then add as many additional IP addresses as needed like this, as bond0:2, bond0:3, etc. It works almost the same as with regular interfaces like eth0, but you must not repeat the bond configuration - that should only be in the bond0 configuration. I know that in order to achieve this with just the eth0 interface, I need to append: auto eth0:0īut how would I go about this with a network bond? Something along the lines of bond0:0 and bond0:1 maybe? Or bond0 and bond1 but create 4 total network interfaces such as: eth0:0 eth1:0 and eth0:1 and eth1:1 and use them as the respective slaves for the two separate bonds? Kinda confusing, but any help would be appreciated!Īs I had this issue myself and there is little information on it anywhere, so here is the 'correct' solution for the /etc/network/interfaces file: auto bond0 I need another interface such as bond1 that can operate on a separate IP address such as 192.168.0.301.

So currently, all connections are routed through bond0.

I have a server with two ethernet ports and I have bonded them together with the following config in /etc/network/interfaces: # The loopback network interface

How does the bonding inteface get mac address on linux